C-618 is a water soluble fluoride release agent, mold release for rubber mold release are excellent, especially the silicone rubber and fluorine rubber. Relative to the other release agent, C-618's from the type of effect is relatively higher Many, after several years of practical experience, will not affect the substrate surface printing 

 Characters: 

 Appearance: light yellow liquid PH value :7-8 

 Advantages: 

 1. Low cost, and can be diluted 6-10 times. 

 2. Production speed, improve efficiency, due to C-618's from the type of particularly good and durable (no spraying has been completed, more modules can be re-fill spray) 

 3. Printing performance particularly good, and does not spray too much bad product generated printing 

 4. Soluble good, safe, good job 

 Operation: 

 1. Use clean before the first mold 

 2. To C-618: Do not use tap water 1:6-10, because properties may be reduced 

 3. Will evenly spray the solution on the mold 

 4. Release was attenuated, and then re-spray 

 The above information is for reference only, the actual operating conditions, as the company operating procedures vary, please adjust the operating conditions for self-testing